Anchors
Heavy Safety Sleeve Anchor
■ Material
Carbon Steel ; Stainless Steel
■ Surface Finish
Zinc Plated ; Ruspert ; Mechanical Zinc Plated
■ Product Description
Heavy Safety Sleeve Anchor is equipped with a ribbed sleeve that interlocks with the concrete during expansion, effectively preventing any rotation or spinning of the anchor body during installation. The multi-point expansion mechanism distributes load across a wider contact area, significantly improving performance under seismic and dynamic loading conditions. It is specifically designed for safety-relevant fastenings where reliability cannot be compromised.
Step 1 - DRILL
Use a hammer drill with the specified carbide bit diameter to drill through the fixture and into the concrete to the required embedment depth.
Step 2 - CLEAN
Remove all dust and debris from the hole using a compressed-air blow gun and a hole brush. Repeat blowing and brushing until the hole is clean.
Step 3 - INSERT
Insert the anchor through the fixture and into the drilled hole until the washer and nut are seated against the fixture surface.
Step 4 - TIGHTEN
Tighten the top hex nut with a calibrated torque wrench to the specified installation torque. This draws the cone upward, expanding the sleeve against the concrete wall and locking the anchor in place.
Step 5 - VERIFY
Verify that the anchor is fully expanded and the fixture is securely fastened.